Bind the receiver to the radio & verify the RX (receiver) channel mapping
Each type of radio operates differently. Refer to your radio instruction manual to bind the receiver to the radio and to set the failsafe.
WARNING! Remove props and disconnect battery before RX (receiver) verification.
Verify the Riot’s connection to the radio from the Receiver tab in Betaflight:
- Using Mode 2 controls, pitch forward and throttle down. Watch the graph in Betaflight to verify the channel mapping. The pitch bar graph should move right as the throttle bar moves left.
- Roll right and verify on Betaflight that the roll graph moves right.
- Yaw left and verify on Betaflight that the yaw graph moves left.
For optimal racing control, refer to your radio manual to correct the sub trim if the stick values don’t hit 1000 at one extreme, 2000 at the other and 1500 in the middle.